R
Page 24
November 5, 2010
Cumberland Gap Wood Stove
7006-188G
7
Appliance Set-Up
All Doors
• Install washer on door handle shaft.
• Slide door handle through door.
Right Front & Side Doors:
• Install additional spacing washer(s) as needed.
• Install bushing, door latch and locknut.
Caution! Do not overtighten locknut. Door handle
needs to move smoothly.
Left Front Door:
• Install locking pin and locknut. Securely tighten locknut.
This handle assembly is stationary.
All Doors
• Insert fi ber door handle with threads going into door
handle shaft. Turn handle clockwise until tight.
Fiber Handle
Handle
Washer
Spacing Washers
Lock
Nut
Door
Latch
Bushing
Lock Nut
Locking Pin
Washer
Door
Handle
Shaft
Fiber
Handle
Left Handle
Assembly is
Stationary
NOTE: When the speed control is turned clockwise, it will
click on to high speed. Turn the speed control clockwise
to decrease the speed. At full clockwise, the blower
should blow gently, but should not stop.
1. With the stove plugged in, turn the speed control knob
to slow (full clockwise).
2. With a small screwdriver, adjust the blower speed by
turning the adjustment mechanism through the hole on
the side of the speed control.
3. Adjust the speed so the blower runs slowly, but does
not stop. Turn clockwise to slow the blower and
counterclockwise to increase the speed.
*The blower speed control for this unit is adjusted at the
factory, and normally does not require further adjustment.
B. Adjusting The Blower Speed Control
*If Necessary
A. Door Handle Assemblies
Figure 24.1 - Left Front Door
Figure 24.2 - Right Front Door
Figure 24.3 - Side Door
