(8) Blade rest plate
(9) L-shaped round rod
(10) Gear case
Look at the blade from above, and
make sure that the direction in which
the blade is mounted is correct.
(1) Rotating direction
Installing the nylon cutter
(available as an option)
Since the resistance of the nylon
cutter is larger than that of the metal
cutter, wrong operation of the nylon
cutter will cause the clutch to
overheat, deform and be damaged.
When using the nylon cutter,
carefully note the following.
• Use ZENOAH’s genuine nylon
cutter. When using a
commercially-available nylon
cutter, make sure that it is no
longer than 10 cm in external
shape.
• Make sure that the length of the
nylon cord is 17 cm or shorter.
• Keep the engine rotating at high
speed while working.
1. Install the blade rest plate and the
outer holder on the gear shaft
correctly, and stop their whirl with
the accessory L-shaped round rod.
2. Screw the mounting bolt (M7 left-
handed) attached to the nylon
cutter into the gear shaft, and
tighten it firmly with a wrench.
[Tightening torque]
14.7 to 19.6 N-m (150 to 200 kgf-cm)
IMPORTANT
IMPORTANT
SE10
