22
English
6. OPERATION
1. Open the fuel cock.
2. Raise the choke lever on the right
of the air cleaner to close the
choke.
When you start the engine again
immediately after stopping it, pull out
the starter rope while keeping the
choke opened.
(1) Choke lever (2) Close
(3) Open (4) Fuel cock
(5) Closed (6) Opened
3. Set the engine stop switch to
“operation.”
4. Set the throttle lever to “idling.”
(1) Throttle lever
(2) Idling
(3) Fully opened
(4) Engine stop switch
(5) Operation
(6) Stop
5. Place the machine on a flat and
firm place, and make sure to keep
the blade clear of everything
around it. Then, holding the main
pipe with your left hand, put your
right foot on the frame, and pull
out the starter knob with your right
hand.
Do not pull out the starter rope up to
its end, and do not let the knob jump
out of the right hand otherwise it may
not return to its original position.
6. When the engine starts, open the
choke gradually.
7. Allow the engine to run for 2 or 3
minutes to warm up before using
the machine.
If you repeat the starting operation
while leaving the choke closed, the
electrodes of the spark plug might
become wet and prevent starting. If
this happens, try the starting
operation again after opening the
choke and pulling out the starter rope
repeatedly, or after taking out the
spark plug and drying the electrodes.
IMPORTANT
IMPORTANT
NOTE
1.연료뚜껑(OP2)을 열어 주십시오.
시오.
주십시오.
하여 주십시오.
설정하여 주십시오.
브를 당겨 주십시오. 스타터 노브
시오.
시오.
어 주십시오.
분간 가열 운전해 주십시오.
이 걸리지 않을 수 있습니다. 이 경우
후 시동조작을 다시 시도해 주십시오.
