Chapter 45 Introducing Commands
ES-4124 User’s Guide
375
45.12.4 interface port-channel Commands
The following table lists the interface port-channel commands in configuration mode.
Use these commands to configure the ports.
<SPTPID> Sets the SP TPID (Service
Provider Tag Protocol Identifier).
13
vlan-type <802.1q|port-
based>
Specifies the VLAN type. 13
wfq Sets the queuing method to
WFQ (Weighted Fair Queuing).
13
wrr Sets the queuing method to
WRR (Weighted Round Robin).
13
Table 141 Command Summary: Configuration Mode (continued)
COMMAND DESCRIPTION PRIVILEGE
Table 142 interface port-channel Commands
COMMAND DESCRIPTION PRIVILEGE
interface
port-
channel
<port-
list>
Enables a port or a list of ports for
configuration.
13
arp inspection trust Sets the port to be a trusted port
for arp inspection. The Switch
does not discard ARP packets on
trusted ports for any reason.
13
limit rate <pps> Specifies the maximum rate (1-
2048 packets per second) at
which the Switch receives ARP
packets from each port. The
Switch discards any additional
ARP packets. Enter 0 to disable
this limit.
13
limit rate <pps>
burst interval
<seconds>
Specifies the length (1-15
seconds) of the burst interval.
The burst interval is the length of
time over which the rate of ARP
packets is monitored for each
port.
13
bandwidth-limit Enables ingress (pir), cir and
egress limits on the port(s).
13
cir Enables the guaranteed
bandwidth limits for incoming
traffic on the port(s).
13
cir <Kbps> Sets the guaranteed bandwidth
allowed for incoming traffic on the
port(s).
13
pir Enables bandwidth limits allowed
for incoming traffic on the port(s).
13
pir <Kbps> Sets the maximum bandwidth
allowed for incoming traffic on the
port(s).
13
