Chapter 45 Introducing Commands
ES-4124 User’s Guide
380
45.12.5 interface route-domain Commands
The following table lists the interface route-domain commands in configuration mode.
speed-duplex <auto|10-half|10-
full|100-
half|100-
full|1000-full>
Sets the duplex mode (half or
full) and speed (10, 100 or
1000 Mbps) of the connection
on the interface. Selecting
auto
(auto-negotiation) makes one
port able to negotiate with a peer
automatically to obtain the
connection speed and duplex
mode that both ends support.
13
trtcm Enables Two Rate Three Color
Marker on the port(s).
13
cir <Kbps> Sets the Commit Information
Rate on the port(s).
13
pir <Kbps> Sets the Peak Information Rate
on the port(s).
13
dscp green <0-63> DSCP value to use for packets
with low packet loss priority.
13
dscp yellow <0-
63>
DSCP value to use for packets
with medium packet loss priority.
13
dscp red <0-63> DSCP value to use for packets
with high packet loss priority.
13
vlan-stacking priority <0-7> Sets the priority of the specified
port(s) in VLAN stacking.
13
role <access |
tunnel>
Sets the VLAN stacking port roles
of the specified port(s).
13
SPVID <1-4094> Sets the service provider VID of
the specified port(s).
13
vlan-trunking Enables VLAN Trunking on ports
connected to other switches or
routers (but not ports directly
connected to end users) to allow
frames belonging to unknown
VLAN groups to pass through the
Switch.
13
weight <wt1>
<wt2> ... <wt8>
A weight value of one to eight is
given to each variable from wt 1
to wt 8.
13
Table 142 interface port-channel Commands (continued)
COMMAND DESCRIPTION PRIVILEGE
