Chapter 48 Interface Commands
ES-4124 User’s Guide
408
• Enable the IEEE 802.1Q tagged VLAN command to configure tagged VLAN for the
Switch.
• Enable ports one, three, four and five for configuration.
• Enable GVRP on the interface.
48.2.8 ingress-check
The ingress-check command enables the device to discard incoming frames for VLANs
that do not have this port as a member.
Syntax:
ingress-check
An example is shown next.
• Enable ports 1, 3, 4 and 5 for configuration.
• Enable ingress checking on the interface.
48.2.9 frame-type
Syntax:
frame-type <all|tagged>
where
An example is shown next.
• Enable ports one, three, four and five for configuration.
• Enable ingress checking on the ports.
• Enable tagged frame-types on the interface.
48.2.10 weight
Syntax:
weight <wt1> <wt2> ... <wt8>
sysname(config)# vlan1q gvrp
sysname(config)# interface port-channel 1,3-5
sysname(config-interface)# gvrp
sysname(config)# interface port-channel 1,3-5
sysname(config-interface)# ingress-check
<all|tagged>
=
Choose to accept both tagged and untagged incoming frames or just tagged
incoming frames on a port.
sysname(config)# interface port-channel 1,3-5
sysname(config-interface)# ingress-check
sysname(config-interface)# frame-type tagged
