Chapter 47 Configuration Mode Commands
ES-4124 User’s Guide
397
where
An example is shown next.
• Disable the secure shell RSA1 encryption key.
• Remove the remote host with IP address 172.165.1.8 from the list of known hosts.
• Remove the remote host with IP address 172.165.1.9 and with an SSH-RSA encryption
key from the list of known hosts.
47.5 Queuing Method Commands
You can use the queuing method commands to configure queuing for outgoing traffic on the
Switch. You can only select one queuing method for the Switch.
Syntax:
spq
wfq
wrr
where
An example is shown next.
• Set the queueing method to SPQ.
key <rsa1|rsa|dsa>
= Disables the secure shell server encryption key. Your
Switch supports SSH versions 1 and 2 using RSA and DSA
authentication.
known-hosts <host-ip>
= Removes a specific remote host from the list of all known
hosts.
known-hosts <host-ip>
[1024|ssh-rsa|ssh-dsa]
= Removes remote known hosts with a specified public key
type (1024-bit RSA1, RSA or DSA).
sysname(config)# no ssh key rsa1
sysname(config)# no ssh known-hosts 172.165.1.8
sysname(config)# no ssh known-hosts 172.165.1.9 ssh-rsa
spq
= Sets the queuing method to SPQ (Strictly Priority Queuing).
wfq
= Sets the queuing method to WFQ (Weighted Fair Queuing).
wrr
= Sets the queuing method to WRR (Weighted Round Robin).
sysname(config)# spq
