A SERVICE OF

logo

Open as PDF
next previous
186 Chapter 9 Image quality EN
If the transparencies have streaks, this could be due to condensed wax
from the toner making its way onto the fuser assembly rollers during the
fusing process. Try cleaning the fuser rollers using the following
process:
1 Saturate a corner of a lint-free, static-free wipe with isopropyl
alcohol.
2 Open the alternate path door (the small door) at the back of the
printer.
3 Place the printer into calibration mode by opening and then closing
the large door at the rear of the printer, or by pulling a drawer open,
and then quickly closing it.
4 While the printer is calibrating, the fuser rollers are rolling. Place the
wipe up against each roller in turn, keeping it in place for 5 to 10
seconds.
Streaking on transparencies
www.GovTechMedia.com