Regulatory Statements iii
Regulatory
Statements
FCC-A This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment
is operated in a commercial environment. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and used in accordance
with the instruction manual, may cause harmful interference to radio communica-
tions. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at
his or her own expense.
This equipment must be installed exactly as instructed in this manual using only
the components supplied. If a supplied component ever needs to be replaced, it
must be replaced with the same part supplied by the manufacturer. It is your
responsibility to follow these instructions in order to maintain compliance with the
FCC regulations. Changes or modifications not expressly approved by the manu-
facturer could void your authority to operate this equipment. In particular, this
device must be operated with shielded cables to maintain FCC compliance.
A booklet is available from the Federal Communications Commission entitled,
How to Identify and Resolve Radio-TV Interference Problems (#004-000-00345-
4). Write to the U.S. Government Printing Office, Washington, DC 20402.
DOC (Canada) This digital apparatus does not exceed the Class A limits for radio noise for digi-
tal apparatus set out in the Radio Interference Regulations of the Canadian
Department of Communications.
Normes de Sècuritè (Canada)
Le présent appariel numérique n’émet pas de bruits radioélectriques dépassant
les limites applicables aux appareils numériques de la Classe A prescrites dans le
réglements sur le brouillage radioélectrique édictés par le Ministére des Communi-
cations du Canada.
Telecommunications
Network Statement
The VideoNet port on this device is not intended to be connected to a public tele-
communications network. Connection of this device to a public telecommunica-
tions network in a European Community Member State will be in violation of
national law implementing Directive 91/263/EEC on the approximation of laws of
the Member States concerning telecommunication terminal equipment, including
the mutual recognition of their conformity.
Der VideoNet port ist nicht dafür vorgesehen an ein öffentliches Telefonnetz
angeschlossen zu werden. Der Anschluß dieses Gerätes an ein öffentliches
Telefonnetz in einem Mitgliedstaat der EU, verstößt gegen nationale Gesetze zur
Ausführung der Direktive 91/263/EEC, die sich mit der Annäherung von
Gesetzen von Mitgliedstaaten beschäftigt, betreffend Telekommuniktionsanlagen
und die gegenseitige Anerkennung ihrer Konformität.
