6 – Removal/Replacement
I/O Blades
6-8 59043-03 A
D
5. Choose the slot number (6 for example).
Which IO blade (indexed by slot number) do you want
to replace? (1,2,3,4,6,7,8,9): [1] 6
6. Disconnect all cables from the selected I/O blade.
Remove all connections from the IO blade in slot 6.
7. Using a flat-bladed screwdriver, loosen the captive screws at the top and
bottom of the I/O blade faceplate as shown in Figure 6-2. The bottom screw
is under the latch. Grasp the latch and press the red release button, then
rotate the latch downward to disengage the I/O blade from the backplane
connector. Carefully slide the I/O blade out of the slot. Enter “y” to confirm
that the I/O blade has been removed.
Remove the IO blade in slot 6 from the chassis.
Have the above operations been completed? (y = proceed / n
= cancel) y
Hotswap IO blade removal sub-procedure successfully
completed.
WARNING!! Voltage is present in an open slot when the switch is operating. To
avoid personal injury or damage to components, do not place
hands or objects into a slot.
AVERTISSEMENT!!
Lorsque le commutateur est en marche, la module est sous
tension. Pour éviter toute blessure personnelle ou dommage aux
composants, ne pas placer les mains ou des objets dans
l’ouverture.
WARNUNG!!
In einem offenen Steckplatz ist Spannung vorhanden, wenn der
Switch in Betrieb ist. Zur Vermeidung von Verletzung oder
Beschädigung von Komponenten weder die Finger noch
irgendwelche Objekte in einen Steckplatz einführen.
CAUTION!
To avoid damaging the latch mechanism, press the red release
button all the way in before rotating the latch.
