B – Command Line Interface
Reset Command
B-30 59043-03 A
D
switch
Resets the switch without a power-on self test. This reset disrupts traffic and
activates the pending firmware. This command also closes all management
sessions. This is the default. To reset the switch with a power-on self test, refer to
the ”Hardreset Command” on page B-16. To reset the switch without disrupting
traffic, refer to the ”Hotreset Command” on page B-20.
system
Resets the system configuration settings to the factory default values. Refer to
Table B-10 for system configuration default values.
zoning
Clears the zoning database and deactivates the active zone set. The zoning
configuration values (autosave, default visibility) remain unchanged.
Notes The following tables specify the various factory default settings:
Table B-5. Switch Configuration Defaults
Parameter Default
Admin State Online
Broadcast Enabled True
InbandEnabled True
FDMIEnabled True
FDMIEntries 1000
Domain ID 1 (0x Hex)
Domain ID Lock False
Symbolic Name SANbox2
R_A_TOV 10000
E_D_TOV 2000
Principal Priority 254
Configuration Description QLogic SANbox2 FC Switch
