B – Command Line Interface
Show Command
B-66 59043-03 A
D
FBusy Number of times the switch sent a F_BSY because Class 2
frame could not be delivered within ED_TOV time. Number
of class 2 and class 3 fabric busy (F_BSY) frames
generated by this port in response to incoming frames.
This usually indicates a busy condition on the fabric or
N_Port that is preventing delivery of this frame.
Flowerrors Received a frame when there were no available credits.
FReject Number of frames from devices that were rejected.
InvalidCRC Invalid CRC detected.
InvalidDestAddr Invalid destination address detected.
LIP ALPD ALPS Number of F7, AL_PS LIPs, or AL_PD (vendor specific)
resets, performed.
LIPF7ALPS This LIP is used to reinitialize the loop. An L_Port,
identified by AL_PS, may have noticed a performance
degradation and is trying to restore the loop.
LIPF8ALPS This LIP denotes a loop failure detected by the L_Port
identified by AL_PS.
LIPF7F7 A loop initialization primitive frame used to acquire a valid
AL_PA.
LIPF8F7 A loop initialization primitive frame used to indicate that a
loop failure has been detected at the receiver.
Link Failures Number of optical link failures detected by this port. A link
failure is a loss of synchronization or by loss of signal while
not in the offline state. A loss of signal causes the switch to
attempt to re-establish the link. If the link is not
re-established, a link failure is counted. A link reset is
performed after a link failure.
Login Number of device logins
Logout Number of device logouts
LoopTimeouts A two (2) second timeout as specified by FC-AL-2.
LossOfSync Number of synchronization losses (>100 ms) detected by
this port. A loss of synchronization is detected by receipt of
an invalid transmission word.
PrimSeqErrors Primitive sequence errors detected.
Table B-19. Show Port Parameters (Continued)
Entry Description
