6 – Removal/Replacement
I/O Blades
6-10 59043-03 A
D
10. Verify the POST results. The I/O blade diagnostic status appears in the
dialog. The status should be "Passed".
Hotswap IO blade process successfully completed.
Diagnostics has been run on the IO blade in slot 6: Passed
11. The system checks the I/O blades for matching Zircon processor firmware. If
any of the I/O blades are not compatible, an alarm message will be
generated indicating that a Zircon firmware mismatch has occurred. To
display the alarm messages, enter the Show Alarm command or use the
SANbox Manager event browser. Refer to ”Show Command” on page B-63
for more information. If a mismatch does occur, contact your authorized
maintenance provider.
SANbox2-64 #> show alarm
[9][Wed Jan 16 13:32:19.500 2003]
[A4101][0xdd0072c2.329][IO-1 Zircon firmware mismatch:
rev 0.5, should be perhaps rev 0.7]
Note: A “Failed” status could indicate a faulty blade or module. Enter
the Show POST Log command for more information or contact
your authorized maintenance provider.
