A SERVICE OF

logo

6 – Removal/Replacement
I/O Blades
59043-03 A 6-9
D
Figure 6-2. Removing an I/O Blade
8. To install a new I/O blade, enter “y”.
Do you want to continue with the replacement procedure?
(y=proceed/n=cancel) y
9. Slide the I/O blade into the slot guide until it makes contact with the
backplane connector. Rotate the blade latch upward to lock the I/O blade in
place. Fasten the screws. Reconnect the Fiber Channel port cables
according to their labels. After confirming that the I/O blade has been
installed, the Port Status LEDs will flash amber in port number sequence,
then the Port Status LEDs will flash green.
o Insert the replacement IO blade into the chassis in slot 6.
o Attach all connections, if any, to the IO blade in slot 6.
Have the above operations been completed? (y = proceed / n =
cancel) y
Release Button
Latch
Screw
Screw
Ground Jack