A SERVICE OF

logo

Open as PDF
next previous
R
December 16, 2011
7014-179D
Page21
CB 1200 Pellet Stove
G. Optional Gold or Nickel Grille Assembly
1. PlacethefrontloginrstasshowninFigure 21.1.Place
logbetweenrepotandfaceofappliancewithcharred
areasurroundingrepot.
2. Settheleftandrightlogsontothefrontlog,placing
theholesinthebaseoftheleftandrightlogsoverthe
locatingpinsinfrontlog.SeeFigure 21.2.Ensurethat
thecharredendsarefacingtherepot.
F. Optional Log Set Placement Instructions
CAUTION
LogsareFRAGILE.Useextremecarewhenhandlingor
cleaninglogs.
NOTE:
Duetotheabrasive natureofapelletappliancere,the
logsarenotcoveredunderwarranty.Anyplacementvaria-
tionotherthanshownherecancauseexcessiveheatand
shallvoidtheappliancewarranty.
LOCATING PINS
Charred Areas in the Back
Top Log
Right
Top Log, Left
Front Log
Figure 21.1
Figure 21.2
Place 1 flap of
box lid into
opening for
stability
CAUTION: Do not open top all the way back so the weight is
supported by the hinges. It will damage the hinges. Prop the
top up with supporting brace or use shipping box as shown.
Align the 3 hoes in the stove
with the holes in the grille and
secure in place.
1. Removegrillefrompackaging.
2. Lifttopupandplaceshippingboxinvertically.
3. Place1apoftheboxlidintoopeningforstability.
4. Alignthe3holesinthestovewiththeholesinthegrille.
5.UseaPhillipsscrewdrivertosecureinplace.
6.Removeshippingboxandlowertop.
Install Logo
1. Removelogofrompackaging.
2. Thelogohas2studsontheback.
3. Installthelogoonthelowerleftsideofthecenter
panelbypressingthe2studsintothepre-drilled
holes.See Figure 21.4.
Donotopentopallthewaybacksotheweightofthe
topissupportedbythehinges. It will damage the
hinges. Itwillbenecessarytopropthetopupwith
asupportingbrace.Youcanusetheshippingboxas
showninFigure1.
CAUTION
Figure 21.3
H. Installing Logo
Figure 21.4