Sony PCS-1/1P Manual

A SERVICE OF

next previous

135Connection Example Using the Data Solution Box

Chapter 5: Data Conference

To use the Communication Transducer connected to the Data Solution Box

• Set “CTE” in the Audio Setup menu to “DSB AUX IN” (page 48).

• Set the SYSTEM SELECT switch at the bottom of the Communication

Transducer to “PCS”.

You cannot use two or more Communication Transducers in a room and cannot use it

with other microphones together.

For detailed information on the Communication Transducer, refer to the

Operating Instructions that come with the Communication Transducer.

To connect the CTE-600 Communication Transducer

Note

AUX MIC 1 MIC 2 MIC 3 MIC 4 MIC 5 TO PROCESSOR RGB OUTOUTLINE OUT IN

to a wall

outlet

to AUX IN

to an input/output connector

to an input/output

connector

Connecting cable

(supplied with the

CTE-600)

to LINE

OUT

Connecting cable

(not supplied)

PCS-DSB1 Data Solution Box (Rear)

CTE-600

AC adaptor

(supplied with

the CTE-600)

Interface box

(supplied with the CTE-600)

to DC 6V

to AUX OUT

to LINE

IN