160 Preparing for a multipoint videoconference
Preparing for a multipoint
videoconference
Notes on installing the MCU software
• You cannot install the software if the write-protect tab on the Memory Stick
in which the MCU software is stored is set to “LOCK”.
• Once the MCU software is installed in the Communication Terminal, the
software will not be used again.
• You cannot install the MCU software which is copied to another Memory
Stick with a computer, etc.
1 Set the power switch on the right side of the Communication Terminal to
the off position (
a).
2 Insert the “Memory Stick” containing the PCS-323M1 or PCS-320M1
MCU software into the Memory Stick slot.
Insert the “Memory Stick” in the direction of the arrow with the mark facing
upward.
3 Set the power switch on the right side of the Communication Terminal to
the on position (
@).
The MCU software is installed in the Communication Terminal.
Installing the MCU software
PCS-323M1 or PCS-320M1 MCU software
