MSL6000 series tape library user guide 115
3054 Need 1 Drive Minimum
(No available drive to run diag.)
• Install or activate a drive.
• Press the Enter button to clear the
message.
• Invalid user initiated operation. Set
parameters correctly and try again.
3055 Memory Allocation Error
(Memory allocation error in diagnostic.)
• Cycle power to the library or reboot by
using the LCD touch display. Wait 30
seconds to power up again.
3057 Invalid Magazine Type
(Unsupported magazine type detected.)
• Upgrade firmware if a newer revision
exists.
• Press the Enter button to clear the
message.
• Check magazine type.
• Invalid user initiated operation. Set
parameters correctly and try again.
3058 Magazine Type Change Not Handled
(Unsupported magazine type detected.)
• Upgrade firmware if a newer revision
exists.
• Press the Enter button to clear the
message.
• Check drive type.
• Invalid user initiated operation. Set
parameters correctly and try again.
3059 Drive Type Not Supported
(Unsupported magazine type detected.)
• Upgrade firmware if a newer revision
exists.
• Press the Enter button to clear the
message.
• Invalid user initiated operation. Set
parameters correctly and try again.
3060 Zone Sequence Error • Cycle power to the library or reboot by
using the LCD touch display.
• Update the Map using the LCD touch
display. (Menu -> Maintenance -> Force
reconfiguration)
3061 Homing Error
(Unable to complete Shuttle Homing
Algorithm.)
• Cycle power to the library or reboot by
using the LCD touch display.
• Update the Map using the LCD touch
display. (Menu -> Maintenance -> Force
reconfiguration)
Table 10 Fault Symptom Codes (continued)
FSC Message ERP
