MSL6000 series tape library user guide 119
307A Diag get drive 2 status failed
(Failed to get drive status, communication
error.)
• Press the Enter button to reboot.
• Ensure the drive shows good status
through the drive status window.
• Deactivate the drive using the GUI control
panel maintenance menu.
• Reseat drive.
• Check cabling.
• Load/unload a cartridge to the drive to
verify.
• Check the tape cartridge used in the last
operation for damage.
• Run the cartridge cycle diagnostic to
verify.
307B Diag get drive 3 status failed
(Failed to get drive status, communication
error.)
• Press the Enter button to reboot.
• Ensure the drive shows good status
through the drive status window.
• Deactivate the drive using the GUI control
panel maintenance menu.
• Reseat drive.
• Check cabling.
• Load/unload a cartridge to the drive to
verify.
• Check the tape cartridge used in the last
operation for damage.
• Run the cartridge cycle diagnostic to
verify.
3082 Drive Stow Failed, Media Returned to
Source
• Press the Enter button to clear the
message.
• Use only media approved for the drive
type.
• Invalid user initiated operation. Set
parameters correctly and try again.
3083 Drive Stow Failed, Media Remains in
Drive
• Press the Enter button to clear the
message.
• Invalid user initiated operation. Set
parameters correctly and try again.
• Ensure cartridges are in magazines.
Table 10 Fault Symptom Codes (continued)
FSC Message ERP
