5: Commands and Levels
XPort Pro Command Reference 106
Displays the current configuration.
Displays the last 20 commands entered during the current
CLI session.
Displays statistics and status information for this lpd line.
Disables sending the start-of-job string after each print job.
Enables sending the start-of-job string after each print job.
Sets the start-of-job text allowing for binary characters.
<binary> = string in binary format that will be sent to the
printer at the
beginning of each print job.
Within [] use binary decimal up to 255 or hex up to 0xFF.
<text>
Sets the start-of-job text.
<text> = ascii string that will be sent to the printer at the
beginning of
<line>
Enters the configure-terminal level.
<line> = number of the terminal line (serial port) to be con-
Enters the configure-terminal level for the network.
test print <number of lines>
Prints lines of text directly to the lpd line.
<number of lines> = number of lines to print.
<line> = number of the tunnel line (serial port) to be confi-
Stores the current configuration in permanent memory.
modbus (modbus) level commands
Sets an additional TCP server port.
Restores the default Modbus Response Timeout.
Exits to the config level.
kill connection <index>
Kills modbus connection selected by index from show
Removes the additional TCP server port.
response timeout <milliseconds>
Sets the Modbus Response Timeout in milliseconds.
Enters the next lower level.
Displays the current configuration.
Displays the last 20 commands entered during the current
CLI session.
Disables the Modbus TCP Server.
Enables the Modbus TCP Server.
Stores the current configuration in permanent memory.
modem (tunnel-modem:1) level commands
Sets the CONNECT string used in modem emulation.
<string> = connect string.
default incoming connection
Default disables incoming network connections.
Default uses text type responses.
display remote ip disable
The incoming RING has nothing following it.
