5: Commands and Levels
XPort Pro Command Reference 117
Sets the TFTP counters to zero.
Returns to the config level.
Restores the TFTP counters to the aggregate values.
Displays the current configuration.
Displays the last 20 commands entered during the current
CLI session.
Displays the TFTP statistics.
Disables the TFTP server.
Stores the current configuration in permanent memory.
traps (config-snmp-traps) level commands
Exits to the next higher level.
Deletes the primary SNMP trap host.
Deletes the secondary SNMP trap host.
primary destination <text>
Sets the primary SNMP trap host.
<text> = IP address of host running the SNMP trap.
secondary destination <text>
Sets the secondary SNMP trap host.
<text> = IP address of host running the SNMP trap.
Shows the current configuration.
Displays the last 20 commands entered during the current
CLI session.
Disables the sending of SNMP trap messages.
Enables the sending of SNMP trap messages.
Stores the current configuration in permanent memory.
tunnel 1 (tunnel:1) level commands
Enters the accept level for this tunnel.
show connection statistics
Zeros all tunnel counters
Enters the connect level for this tunnel.
Enters the disconnect level for this tunnel.
Exits to the enable level.
Enters the line level.
<line> = number of the line (serial port) to be configured.
Enters the configure lpd level.
<line> = number of the line (lpd serial port) to be confi-
Enters the modem level for this tunnel.
Unzeros all tunnel counters
Enters the packing level for this tunnel.
Enters the serial line PPP level.
Enters the serial level for this tunnel.
show history Displays the last 20 commands entered during the current
show connection statistics
Enters the configure-terminal level.
