5: Commands and Levels
XPort Pro Command Reference 108
Displays the current configuration.
Displays the last 20 commands entered during the current
CLI session.
Sets the threshold (byte count). If the queued data reach-
es this threshold
then the data will be sent.
<bytes> = number of bytes in the threshold.
Sets the timeout value for packing mode in milliseconds.
<milliseconds> = timeout value, in milliseconds.
trailing character <control>
Sets the trailing character for packing mode.
The character may be input as text, control, decimal, or
hex.
A control character has the form <control>C.
A decimal value character has the form \99.
A hex value character has the form 0xFF.
Stores the current configuration in permanent memory.
password (tunnel-accept-password:1) level commands
Exits to the next higher level.
Removes the password so connections will be accepted
unchallenged.
Sets the password required on the network side of the
tunnel to begin
Inhibits any prompting for password on the network side of
the tunnel.
Sets up so a user on the network side of the tunnel will be
prompted for
Shows the current configuration.
Displays the last 20 commands entered during the current
CLI session.
Stores the current configuration in permanent memory.
ppp 1 (ppp:1) level commands
Sets authentication to Challenge-Handshake Authentica-
tion Protocol (CHAP).
authentication mode ms-chap
Sets authentication to MS-CHAP version 1.
authentication mode ms-chapv2
Sets authentication to MS-CHAP version 2.
Removes PPP authentication.
Sets authentication to Password Authentication Protocol
(PAP).
default authentication mode
Removes PPP authentication.
Exits to the configuration level.
Enters the line level.
<line> = number of the line (serial port) to be configured.
local ip <ip address/cidr>
Sets the Local IP address and network mask.
Formats accepted:
192.168.1.1 (default mask)
192.168.1.1/24 (CIDR)
"192.168.1.1 255.255.255.0" (explicit mask)
Enters the configure lpd level.
