GS-4012F/4024 User’s Guide
263 Chapter 40 Introducing the Commands
broadcast-limit
Disables broadcast storm
control limit on the port(s).
diffserv
Disables DiffServ on the port(s).
dlf-limit
Disables destination lookup
failure (DLF) on the switch.
egress-set <port-
list>
Disables the egress port setting.
flow-control
Disables flow control on the
port(s).
gvrp
Disable GVRP on the port(s).
igmp-filtering
profile
Disables IGMP filtering.
igmp-group-limit
Disables IGMP group limitation.
igmp-immediate-
leave
Disables the IGMP immidiate
leave function.
inactive
Enables the port(s) on the
switch.
ingress-check
Disables ingress checking on
the port(s).
intrusion-lock
Disables intrusion-lock on a port
so that a port can be connected
again after you disconnected
the cable.
mirror
Disables port mirroring on the
port(s).
multicast-limit
Disables multicast limit on the
port(s).
vlan-trunking
Disables VLAN trunking on the
port(s).
pvid <1-4094>
The default PVID is VLAN 1 for
all ports. Sets a PVID in the
range 1 to 4094 for the specified
interface.
qos priority <0 .. 7>
Sets the quality of service
priority for an interface.
speed-duplex <auto|10-half|10-
full|100-half|100-
full|1000-full>
Sets the duplex mode (half or
full) and speed (10, 100 or
1000 Mbps) of the connection
on the interface. Selecting
auto (auto-negotiation) makes
one port able to negotiate with a
peer automatically to obtain the
connection speed and duplex
mode that both ends support.
spq
Sets the port(s) to use Strict
Priority Queuing.
test
Performs an interface loopback
test.
Table 96 interface port-channel Commands (continued)
COMMAND DESCRIPTION
