GS-4012F/4024 User’s Guide
Chapter 40 Introducing the Commands 264
40.9.5 interface route-domain Commands
The following table lists the interface route-domain commands in configuration mode.
Use these commands to configure the IP routing domains.
vlan-stacking priority <0-7>
Sets the priority of the specified
port(s) in VLAN stacking.
role <access |
tunnel>
Sets the VLAN stacking port
roles of the specified port(s).
SPVID <1-4094>
Sets the service provider VID of
the specified port(s).
vlan-trunking
Enables VLAN Trunking on
ports connected to other
switches or routers (but not
ports directly connected to end
users) to allow frames
belonging to unknown VLAN
groups to pass through the
switch.
wrr
Sets the port(s) to use Weighted
Round Robin queuing (WRR).
<wt1> <wt2> ...
<wt8>
Sets the interface to use WRR
queuing. A weight value of one
to eight is given to each variable
from
wt1 to wt8.
Table 96 interface port-channel Commands (continued)
COMMAND DESCRIPTION
Table 97 interface route-domain Commands
COMMAND DESCRIPTION
interface
route-domain
<ip-address>/
<mask-bits>
Enables a routing domain for configuration.
exit
Exits from the interface routing-domain
command mode.
ip dvmrp
Enables this function to permit VLAN groups
beyond the local switch.
igmp <v1|v2>
Enables IGMP in this routing domain.
ospf authentication-
key <k>
Enables OSPF authentication in this routing
domain.
ospf authentication-
same-aa
Sets the same OSPF authentication settings in
the routing domain as the associated area.
ospf cost <1-65535>
Sets the OSPF cost in this routing domain.
ospf message-digest-
key <k>
Sets the OSPF authentication key in this
routing domain.
