GS-4012F/4024 User’s Guide
57 Chapter 4 The Web Configurator
4.5.1 Reload the Configuration File
Uploading the factory-default configuration file replaces the current configuration file with the
factory-default configuration file. This means that you will lose all previous configurations
and the speed of the console port will be reset to the default of 9600bps with 8 data bit, no
parity, one stop bit and flow control set to none. The password will also be reset to “1234” and
the IP address to 192.168.1.1.
To upload the configuration file, do the following:
1 Connect to the console port using a computer with terminal emulation software. See
Section 3.1.1 on page 45 for details.
2 Disconnect and reconnect the switch’s power to begin a session. When you reconnect the
switch’s power, you will see the initial screen.
3 When you see the message “
Press any key to enter Debug Mode within 3
seconds ...
” press any key to enter debug mode.
4 Type
atlc after the “Enter Debug Mode” message.
5 Wait for the “
Starting XMODEM upload” message before activating XMODEM
upload on your terminal.
6 After a configuration file upload, type
atgo to restart the switch.
Figure 21 Resetting the Switch: Via the Console Port
The switch is now reinitialized with a default configuration file including the default password
of “1234”.
4.6 Logging Out of the Web Configurator
Click Logout in a screen to exit the web configurator. You have to log in with your password
again after you log out. This is recommended after you finish a management session for
security reasons.
Bootbase Version: V1.0 | 11/26/2004 15:56:35
RAM:Size = 64 Mbytes
FLASH: Intel 32M
ZyNOS Version: V3.60(LL.0)b2 | 01/18/2005 00:39:28
Press any key to enter debug mode within 3 seconds.
....................
Enter Debug Mode
GS-4012F> atlc
Starting XMODEM upload (CRC mode)....
CCCCCCCCCCCCCCCC
Total 393216 bytes received.
Erasing..
................................................................
OK
GS-4012F> atgo
