GS-4012F/4024 User’s Guide
Chapter 41 Command Examples 270
Figure 161 show ip Command Example
41.2.4 show logging
Note: This command is not available in User mode.
Syntax:
show logging
This command displays the system logs. The following figure shows an example.
Figure 162 show logging Command Example
Note: If you clear a log (by entering y at the Clear Error Log (y/n):prompt), you
cannot view it again.
41.2.5 show interface
Syntax:
show interface [port-number]
This command displays statistics of a port. The following example shows that port 2 is up and
the related information.
ras> show ip
Management IP Address
IP[192.168.0.1], Netmask[255.255.255.0], VID[0]
IP Interface
IP[192.168.1.1], Netmask[255.255.255.0], VID[1]
ras>
ras# show logging
0 Thu Jan 1 00:00:11 1970 PP2b INFO adjtime task pause 1 day
7 Thu Jan 1 01:06:26 1970 PP23 ERROR ospfReadConf: can't get spOSPFArea_t
10 Thu Jan 1 01:06:38 1970 PP23 ERROR ospfReadConf: can't get spOSPFArea_t
13 Thu Jan 1 01:06:50 1970 PP23 ERROR ospfReadConf: can't get spOSPFArea_t
16 Thu Jan 1 01:07:05 1970 PP23 ERROR ospfReadConf: can't get spOSPFArea_t
20 Thu Jan 1 00:00:04 1970 PP0c -WARN SNMP TRAP 3: link up
21 Thu Jan 1 00:00:06 1970 PINI -WARN SNMP TRAP 1: warm start
22 Thu Jan 1 00:00:06 1970 PINI -WARN SNMP TRAP 3: link up
22 Thu Jan 1 00:00:06 1970 PINI -WARN SNMP TRAP 3: link up
24 Thu Jan 1 00:00:07 1970 PP23 ERROR ospfReadConf: can't get spOSPFArea_t
25 Thu Jan 1 00:00:11 1970 PP2b INFO adjtime task pause 1 day
30 Thu Jan 1 00:00:04 1970 PP0c -WARN SNMP TRAP 3: link up
31 Thu Jan 1 00:00:06 1970 PINI -WARN SNMP TRAP 1: warm start
32 Thu Jan 1 00:00:06 1970 PINI -WARN SNMP TRAP 3: link up
Clear Error Log (y/n):
