IES-1000 User’s Guide
1-2 Getting to Know the IES-1000
G.dmt (ITU-T G.992.1)
G.lite (ITU-T G.992.2)
G.hs (ITU-T G.994.1)
ANSI T1.413 issue 2
• Rate adaptation support
Port Bonding (SAM1008)
The port bonding feature allows you to combine two to four G.SHDSL connections between two IES-1000s into a
single logical connection. This can give increased bandwidth for LAN-to-LAN applications.
Bridging
• IEEE 802.1D transparent bridging
• Up to 4096 MAC entries address table
• Port-based VLAN (Virtual Local Area Network)
IEEE 802.1Q Tagged VLAN
Your IES-1000 uses the IEEE 802.1Q Tagged VLAN (Virtual Local Area Network), which allows your device to
deliver tagged/untagged frames to and from its ports. The IES-1000 supports up to 255 VLANs and up to 4094
VLAN IDs.
IEEE 802.1p Priority
Your IES-1000 uses IEEE 802.1p Priority to assign priority levels to individual ports.
Fast Mode
The fast mode makes use of the “tag” subset of the IEEE 802.1Q standard to identify the source port of a frame
and speed traffic through a service gateway.
MAC (Media Access Control) Filtering
Use MAC filter commands to filter incoming frames based on MAC (Media Access Control) address(es) that you
specify. You may enable/disable specific ports. You may specify up to five MAC addresses per port.
Secured Host
Allow up to ten remote hosts to access your IES-1000 via IP addresses you specify.
System Error Logging
The system error log will record error logs locally to the IES-1000 memory. These logs may be viewed again after
a warm restart.
UNIX Syslog Logging
Use UNIX syslog commands to send logs to your UNIX server.
Protocol
• Multiple Protocols over AAL5 (RFC 1483)
