IES-1000 User’s Guide
G.SHDSL Commands 6-9
6.6.16 Set Ports Command
Syntax:
192.168.1.1 gshdsl> set ports <profile name>
where
<profile name> =
The profile that defines the minimum and maximum transfer rates for this
port.
This CI command is like the Set Port Command described in section 6.6.15 except that this command
configures all G.SHDSL ports to have a specified profile. Enter the list ports command to view the status
of all ports.
6.6.17 Set PVC Command
Syntax:
192.168.1.1 gshdsl> set pvc <port #> <multiplexing mode> <tx vpi> <tx vci>
[<rx vpi> <rx vci>]
where
<port #> =
A port number, from 1 to 8.
<multiplexing mode> =
Either “llc” or “vc"
<tx vpi> =
The VPI setting of the G.SHDSL port for use with a TX based
network.
<tx vci> =
The VCI setting for the G.SHDSL port for use with a TX based
network.
<rx vpi> =
The VPI setting for the G.SHDSL port for use with Rx based
networks.
<rx vci> =
The VCI setting for the G.SHDSL port for use with Rx based
networks.
The <rx vpi> and <rx vci> settings will be equal to those of <tx vpi> and <tx vci> if the rx
settings are not configured.
The set pvc command allows the configuration of a PVC (permanent virtual circuit) for an individual
G.SHDSL port.
6.6.18 Set PVCs Command
Syntax:
192.168.1.1 gshdsl> set pvcs <multiplexing mode> <tx vpi> <tx vci> [<rx
vpi> <rx vci>]
where
<multiplexing mode>=
Either “llc” or “vc”.
<tx vpi> =
The VPI setting of the G.SHDSL ports for use with a TX based
network.
