IES-1000 User’s Guide
ADSL Commands 7-3
• Multiplexing: LLC-based
• VPI : 0
• VCI : 33
• Enable/Disable State: disabled
• Operational mode: auto
7.5 ADSL Commands
7.5.1 Config Save Command
Syntax:
192.168.1.1 adsl> config save
The config save command saves the ADSL configuration into nonvolatile memory.
7.5.2 Disable Port Command
Syntax:
192.168.1.1 adsl> disable port <port number>
where
<port number> = port number, from 1 to 8.
The disable port command forcibly disables the specified ADSL port.
The factory default of all ports is disabled. A port must be enabled before data transmission can
occur. An enabled but disconnected ADSL port generates more heat than an operating port. To
minimize heat generation and to enhance reliability, remember to disable a port when it is not in
use.
7.5.3 Disable Ports Command
Syntax:
192.168.1.1 adsl> disable ports
The disable ports command forcibly disables all ADSL ports.
The factory default of all ports is disabled. A port must be enabled before data transmission can
occur. An enabled but disconnected ADSL port generates more heat than an operating port. To
minimize heat generation and to enhance reliability, remember to disable a port when it is not in
use.
