IES-1000 User’s Guide
7-12 ADSL Commands
where
<profile name> =
The profile that will define the settings of this port.
<oper mode> =
Operational mode. Choose from glite, gdmt, t1413 or auto for Annex
A. Choose from anxb or auto for Annex B.
The set ports command assigns a specific profile to all of the ADSL ports and sets all of the ports to one
mode, or standard. The profile defines the maximum and minimum upstream/downstream rates, the target
upstream/downstream signal noise margins, and the maximum and minimum upstream/downstream acceptable
noise margins of all the ADSL ports.
The mode parameter specifies the standard that this port is allowed. When set to auto, the AAM1008 follows
whatever mode is set on the other end of the line.
When the mode is set to auto and the negotiated mode is G.lite, if the configured rates exceed
those allowed by G.lite, the actual rates are governed by G.lite, regardless of the configured
numbers.
7.5.19 Show Port Command
Syntax:
show port <port number>
where
<port number> = A port number, from 1 to 8.
The show port command shows the line status (up or down), the actual upstream/downstream rates and mode of
an individual ADSL port.
7.5.20 Show Ports Command
Syntax:
192.168.1.1 adsl> show ports
The show ports command shows the line status (up or down), the actual upstream/downstream rates and the
mode of all ADSL ports.
7.5.21 Set PVC Command
Syntax:
192.168.1.1 adsl> set pvc <port number> <multiplexing mode> <tx vpi>
<tx vci> [<rx vpi> <rx vci>]
where
<port number> = A port number, from 1 to 8.
