IES-1000 User’s Guide
5-6 System Commands
5.6.3 Secured Host Delete Command
Syntax:
192.168.1.1 sys> secured host delete <host IP>
where
<host IP> =
The IP address of a secured host.
This command deletes the IP address of a previously added secured host.
5.7 UNIX Syslog Commands
Use UNIX syslog commands to send logs to your UNIX server. If the DSL link is on or goes down, the IES-1000
will send a log to your UNIX server. The table, shown next, indicates what is logged in each case.
Table 5-1 Logs Sent to Your UNIX Server
DSL LINK ON DSL LINK DOWN
port number port number
sequence number sequence number
rate -
If your UNIX server is down these logs will be lost.
5.7.1 Syslog Command
Syntax:
192.168.1.1 sys> syslog [<mode>]
where
<mode> =
enable or disable.
This command enables or disables the sending of logs to your UNIX server. Syslog is disabled by default
(<mode>= disable). A log is sent if <mode>= enable. To display current settings, do not specify a
<mode>.
5.7.2 Syslog Facility Command
Syntax:
192.168.1.1 sys> syslog facility <facility>
where
<facility> =
Local 1 to local 7.
This command sets the syslog facility for the UNIX system.
