IES-1000 User’s Guide
G.SHDSL Commands 6-11
192.168.1.1 gshdsl> set bondc <ports list>
where
<ports list> =
Two to four G.SHDSL ports.
This command bonds the listed ports into a single port for the STU-C (SHDSL Termination Unit – Central).
One IES-1000 must be set to be the central side and the other must be set to be the remote side. Configure both
with the same number of ports set to connect to the other IES-1000 and bonded.
You can bond multiple groups of ports as long as they do not overlap. One SAM1008 module can have both
STU-C and STU-R groups.
An example is shown next.
192.168.1.1 gshdsl> set bondc 2 3 7 8
This bonds ports 2, 3, 7 and 8 together into a logical link and sets this IES-1000 to be the STU-C.
Make sure you set all of the bonded ports to have the same PVID see 10.6.3 PVID Command.
6.6.23 Set Remote Side Port Bonding Command
Syntax:
192.168.1.1 gshdsl> set bondr <ports list>
where
<ports list> =
Two to four G.SHDSL ports.
This command bonds the listed ports into a single port for the STU-R (SHDSL Termination Unit – Remote).
One IES-1000 must be set to be the central side and the other must be set to be the remote side. Configure both
with the same number of ports set to connect to the other IES-1000 and bonded.
You can bond multiple groups of ports as long as they do not overlap. One SAM1008 module can have both
STU-C and STU-R groups.
An example is shown next.
192.168.1.1 gshdsl> set bondr 2 3 7 8
This bonds ports 2, 3, 7 and 8 together into a logical link and sets this IES-1000 to be the STU-R.
Make sure you set all of the bonded ports to have the same PVID see 10.6.3 PVID Command.
6.6.24 Delete Port Bonding Command
Syntax:
192.168.1.1 gshdsl> delete bond <ports list>
where
<ports list> =
Two to four G.SHDSL ports.
