A SERVICE OF

logo

Open as PDF
next previous
IES-1000 User’s Guide
IEEE 802.1Q Tagged VLAN Commands 10-5
This command sets the VLAN ID to a specific port in the PVID table. To display the PVID table simply enter
this command without parameters, as shown next.
192.168.1.1 vlan1q> pvid
Figure 10-1 Example: PVID Command Display
Make sure you set all bonded ports to have the same PVID.
10.6.4 SVLAN CPU Command
Syntax:
192.168.1.1 vlan1q> svlan cpu [<vid>]
where
<vid> =
A VLAN ID. Valid parameter range = [1 – 4094].
This command registers your CPU as a port member of the static VLAN with <vid>. To display the CPU
static VLAN identification, simply enter this command without parameters, as shown next.
192.168.1.1 vlan1q> svlan cpu
10.6.5 SVLAN List Command
Syntax:
192.168.1.1 vlan1q> svlan list
pvid port#
----- -----
1 1
1 2
1 3
1 4
1 5
1 6
1 7
1 8
1 9
192.168.1.1 vlan1q>