IES-1000 User’s Guide
10-10 IEEE 802.1QTagged VLAN Commands
Figure 10-6 Example: DVLAN List Command Display
In the figure above, “||” denotes “filter” and “>>” denotes “forward”.
10.6.10 DVLAN Getentry Command
Syntax:
192.168.1.1 vlan1q> dvlan getentry <vid>
where
<vid> =
A VLAN ID. Valid parameter range = [1 – 4094].
This command displays an entry with a specified VLAN ID in dynamic GVRP table.
Display a Dynamic VLAN Table Entry Example
The following figure is an example display of the following command.
192.168.1.1 vlan1q> dvlan getentry 2
Figure 10-7 Example: DVLAN Getentry 2 Command Display
In the figure above, “||” denotes “filter” and “>>” denotes “forward”.
10.6.11 VLAN List Command
Syntax:
192.168.1.1 vlan1q> vlan list
This command displays the entire VLAN table. The display refreshes periodically. Press [ENTER] and then
enter the stop command to stop the display from refreshing. The following figure is an example what is
displayed when you use this command.
vid 01 02 03 04 05 06 07 08 09
---- ---- ---- ---- ---- ---- ---- ---- ---- ----
2
>>
>
>
>
vid 01 02 03 04 05 06 07 08 09
---- ---- ---- ---- ---- ---- ---- ---- ---- ----
2 || >> || || >> >> || || >>
3 >> >> || || || >> >> >> ||
4 >> || || >> >> || || >> >>
5 || >> || || >> >> || || >>
6 >> >> || || || >> >> >> ||
7 || >> || >> >> || || >> >>
8 >> || || >> || >> >> >> >>
>>
>
>>
>
