VES-1000 Series Ethernet Switch
VDSL-Related Commands 12-1
This chapter shows you how to configure VDSL using line interface commands.
12.1 Introduction
CI commands are an alternative way (to SMT menus) of configuring your VES-1000 Series switch. They contain
more advanced features that may be used for debugging and troubleshooting. Please exercise caution when using
CI commands as incorrect usage may damage your VES-1000 Series switch.
12.1.1 VDSL Default Values
The default values for the following VDSL parameters are shown in the next table.
Table 12-A VDSL Default Values
VDSL PARAMETER DEFAULT VALUE
VDSL Mode 0 = 10BaseS mode
VDSL Active Off
VDSL Upstream Rate 12.5 Mbps
VDSL Downstream Rate 12.5 Mbps
Enter 8 from menu 24 to go to CI command mode.
Figure 12-1 CI Command Mode
Type “?” to see the first level of commands.
Chapter 12
VDSL-Related
Commands
Menu 24 — System Maintenance
1. System Status
2. System Information and Console Port Speed
3. Log and Trace
4. Diagnostic
5. Backup Configuration
6. Restore Configuration
7. Upload Firmware
8. Command Interpreter Mode
11. Remote Management Control
12. Hardware Monitor
Enter Menu Selection Number:
