VES-1000 Series Ethernet Switch
VDSL-Related Commands 12-7
This command clears the status counters of the specific VDSL channel.
12.2.10 VDSL Show Command
vdsl show chan-id
This command displays your VDSL driver settings for the channel you specify.
Figure 12-5 VDSL Show Example
12.2.11 VDSL Quality Command
vdsl quality chan-id
Use this command to view error counters on your VDSL link.
Figure 12-6 VDSL Quality Counters
Refer to Table 12-E for more information on these fields.
12.2.12 VDSL Debug Command
vdsl debug chan-id [on|off]
This command turns the VDSL auto flag on or off or just shows the current VDSL auto flag status (without “on”
or “off”). When this flag is on, the VES-1000 Series switch displays each stage (state) of the VDSL link
initialization process. When the VDSL link is up, no messages are displayed until the VDSL line is disconnected.
ves100> vdsl show vdsl01
VDSL Channel vdsl01 Setting:
VDSL Port: enable
VDSL mode: 10BaseS
VDSL Max. upstream rate: 4
VDSL Max. downstream rate: 4
VDSL Curr. upstream rate: 4
VDSL Curr. downstream rate: 4
VDSL state: 4
VDSL auto flag: off
VDSL monitor flag: off
VDSL debug flag: off
VDSL auto upgrade NT EEPROM flag: off
VDSL enet monitor flag: off
NT Ethernet Speed: Auto
NT Ethernet Flow Control: Enable
ves100>
ves-100> vdsl quality chan1
US US US US US DS DS DS DS DS
CHAN Lnk RATE SNR MSE TXPWR RSERR RATE SNR MSE TXPWR RSERR
Mbps dB dB dbm/Hz Mbps dB dB dbm/Hz
