VES-1000 Series Ethernet Switch
3-4 Introducing the SMT
Figure 3-4 VES-1012 Main Menu
The following table shows the VES-1000 Series switch Main Menu summary:
Table 3-B Main Menu Summary
# MENU TITLE DESCRIPTION
1 General Setup Use this menu to enter VES-1000 Series switch administrative information.
2 Switch Setup Use this menu to set the switch parameters, including STP setup, GARP timers
and QS parameters.
3 IP Setup Use this menu to set up TCP/IP parameters such as the IP address, subnet
mask and default gateway.
6 Port Setup Configure your VDSL and Ethernet ports in this menu including individual port
STP configuration.
12 Static Routing Setup Use this menu to set up static routes.
17 VLAN Setup Configure switch VLAN setup in this menu.
22 SNMP Configuration Use this menu to set up SNMP related parameters
23 System Password Use this menu to change your system password.
24 System Maintenance Configure menus for System Status, System Information/Console Port Speed,
Log and Trace, Diagnostic, Backup, Restore, Firmware Update, Command
Interpreter Mode, Time and Date Setting, Remote Management Control and
Hardware Monitor here.
99 Exit To exit a system configuration/management session via SMT you must type 99.
You then return to a blank screen.
3.4 Changing the System Password
It’s important to change the default system password by doing the following:
Step 1. Enter 23 from the main menu. This will open Menu 23 – Change Password as shown next.
Step 2. Type the existing system password (“1234” is the default password when shipped), then press
[ENTER].
Copyright (c) 2000,2001 ZyXEL Communications Corp.
VES-1012 Main Menu (VDSL_1)
Getting Started Advanced Management
1. General Setup
2. Switch Setup 22. SNMP Configuration
3. IP Setup 23. System Password
24. System Maintenance
6. Port Setup
Advanced Applications
12. Static Routing Setup
17. VLAN Setup
99. Exit
Enter Menu Selection Number:
