VES-1000 Series Ethernet Switch
Firmware and Configuration File Maintenance 10-13
Figure 10-17 Example Xmodem Upload
After the firmware upload process has completed, the VES-1000 Series switch will automatically restart.
10.4.10 Uploading Configuration File Via Console Port
Step 1. Select 2 from Menu 24.7 – System Maintenance – Upload Firmware to display Menu 24.7.2 —
System Maintenance — Upload System Configuration File. Follow the instructions as shown in the
next screen.
Figure 10-18 Menu 24.7.2 as seen using the Console Port
Step 2. After the "Starting Xmodem upload" message appears, activate the Xmodem protocol on your
computer. Follow the procedure as shown previously for the HyperTerminal program. The procedure
for other serial communications programs should be similar.
Step 3. Enter “atgo” to restart the VES-1000 Series switch.
10.4.11 Example Xmodem Configuration Upload Using
Menu 24.7.2 — System Maintenance — Upload System Configuration File
To upload system configuration file:
1. Enter "y" at the prompt below to go into debug mode.
2. Enter "atlc" after "Enter Debug Mode" message.
3. Wait for "Starting XMODEM upload" message before activating
Xmodem upload on your terminal.
4. After successful firmware upload, enter "atgo" to restart the
router.
Warning:
1. Proceeding with the upload will erase the current
configuration file.
2. The router's console port speed (Menu 24.2.2) may change
when it is restarted; please adjust your terminal's speed
accordingly. The password may change (menu 23), also.
3. When uploading the DEFAULT configuration file, the console
port speed will be reset to 9600 bps and the password to
"1234".
Do You Wish To Proceed:(Y/N)
Choose the Xmodem protocol.
Then click Send.
Type the firmware file’s
location, or click Browse to
look for it.
