10
10.8 Administrator Settings
10-40
Utility Mode Operations Chapter 10
Setting the “Access Lock” Function
This function is used to specify penalties for incorrect access attempts (when the
administrator code, account access number or unlocking code for locked jobs are
incorrectly entered).
(The default setting is “Disable”.)
✎
Condition
If this function is set to “Enable”, entering an incorrect access number
(administrator code, account access number or unlocking code for locked jobs)
a total of three times (consecutively for the account access number and
unlocking code for locked jobs) will result in input of the access number being
denied.
For account access number, the number of incorrect attempts is counted
separately for each account.
The following message appears when input of the administrator code is denied.
The following procedures describe how to allow access number to be entered
after it has been denied.
If input of the administrator code is denied: Turn this machine off, then on again.
If input of access number other than the administrator code is denied: Turn this
machine off, then on again, or use the “Access Lock Release” function on the
Admin. Set screen.
✎
Reference
For details on clearing access locks, refer to “Setting the “Access Lock Release”
Function” on page 10-42.
