12.2 When the Machine Is Not Operating Correctly
12
12-5
Troubleshooting Chapter 12
12.2 When the Machine Is Not Operating Correctly
Symptom Possible Cause Remedy
Nothing appears in the touch
panel.
The indicators on the [Start] key
and [Power Save] key light up in
green.
The machine is in Power Save
mode.
Press any key in the control
panel to cancel Power Save
mode. (See page 2-18.)
The contrast-adjusting dial for
the touch panel has been set
either too light or too dark.
While looking at the touch panel,
adjust the contrast dial. (See
page 2-12.)
The indicator on the [Start] key
does not light up in green.
An access number has not been
entered.
Enter the access number
according to the procedure
described in “Making Copies
With an Account”. (See
page 6-10.)
Even though the [Start] key is
pressed, no copies are made.
The copy/print job is queued and
waiting to be printed.
Touch [Job Log] to check the
jobs that are queued. Wait until
printing begins.
The machine is still warming up
after just being turned on.
The machine takes 99 seconds
to warm up after it is turned on.
Wait until the machine has
finished warming up.
The machine is malfunctioning. Follow any messages that
appear on the touch panel.
The machine cannot be set to
Copy mode.
If the indicator on the [Interrupt]
key is lit, the machine is in
Interrupt mode.
Specify the copy settings for the
job that copying is interrupted
for. Press the [Interrupt] key to
cancel Interrupt mode. (See
page 6-8.)
The machine cannot be turned
on.
The power supply cord has been
unplugged from the electrical
outlet.
Plug the power supply cord into
the electrical outlet.
The breaker for the electrical
circuit has been tripped.
Close the breaker for the
electrical circuit.
