iPodா* PLAYER OPERATION WITH
NAVIGATION SYSTEM (if so
equipped)
Connecting iPodா
To connect an iPodா to the vehicle so that the
iPodா can be controlled with the audio system
controls and display screen, use the USB jack
located in the center console. Open the protective
cover
᭺
1
on the USB jack in the center console.
Then connect the iPodா-specific end of the cable
to the iPodா and the USB end of the cable to the
USB jack on the vehicle. If your iPodா supports
charging via a USB connection, its battery will be
charged while connected to the vehicle with the
ignition switch in the ACC or ON position.
While connected to the vehicle, the iPodா can
only be operated by the vehicle audio controls.
To disconnect the iPodா from the vehicle, remove
the USBend ofthe cablefrom theUSB jack onthe
vehicle, then remove the cable from the iPodா.
*iPodா is a trademarkof Apple Inc., registered in
the U.S. and other countries.
Compatibility
The following models are compatible:
● iPodா 5th Generation version 1.2.3
● iPodா Classic - version 1.1.1
● iPodா Touch - version 2.0.0*
● iPodா Nano - 1st generation version 1.3.1
● iPodா Nano - 2nd generation version 1.1.3
● iPodா Nano - 3rd generation version 1.1.3
● iPodா Nano - 4th generation version 1.0.4
● iPodா Nano - 5th generation version 1.0.1
* Some features of this iPodா may not be fully
functional.
Make surethat youriPodா firmwareis updatedto
the version indicated above.
Audio main operation
Place the ignition switch in the ACC or ON
position. Press the DISC·AUX button repeatedly
to switch to the iPodா mode.
If the system has been turned off while the iPodா
was playing, pressing the VOL/ON·OFF control
knob will start the iPodா.
DISC·AUX button:
When the DISC·AUX button is pressed with the
system off and the iPodா connected, the system
will turnon. Ifanother audiosource isplaying and
the iPodா is connected, press the DISC·AUX
button repeatedly until the center display
changes to the iPodா mode.
WHA1530 LHA1397
Monitor, climate, audio, phone and voice recognition systems 4-67
