Chapter 24 Troubleshooting
MES-2110 User’s Guide
211
24.3 MES-2110 Configuration and Console
I’m trying to configure MVR but I get an error message.
MVR only functions with Tag-Based (802.1q) VLANs. To rectify this:
• Open the Configuration > VLAN Menu > VLAN Type screen and set the
VLAN Type option to Tag-Based (802.1q).
Or
• Connect to the MES-2110 through the console port (Chapter 23 on page 179)
and enter the following commands:
.
I applied changes in the Web Configurator but they are not taking effect.
• Makes sure that you saved all configuration changes using the Save Settings
link in the Web Configurator’s navigation pane.
• Clean out the cache of the browser that you are using to connect to the MES-
2110’s Web Configurator, and make sure that you’re only using a browser
supported by the device (Chapter 1 on page 19)
• Try making your changes through the MES-2110’s command line interface
(Chapter 23 on page 179), and using the write memory command to make the
changes permanent.
• Power off the MES-2110, then power it back on and make your changes afresh.
• Reset the MES-2110 to its factory default settings (Section 5.6 on page 59).
• If the problem continues, contact the vendor.
MES-2110: enable
MES-2110# configure terminal
MES-2110(config)# vlan-type 802.1q
