Chapter 10 802.1x
MES-2110 User’s Guide
80
10.3 802.1x Radius Server Configuration Screen
Use this screen to configure the RADIUS server settings.
Click Configuration > 802.1x > Radius Server Configuration in the
navigation panel to display the screen as shown.
Figure 33 Configuration > Radius Server Configuration
The following table describes the labels in this screen.
Table 16 Configuration > Radius Server Configuration
LABEL DESCRIPTION
Server IP
Address
Enter the IP address of the external authentication server in dotted
decimal notation.
Server
Shared Key
Enter a password (up to 128 alphanumeric characters) as the key to be
shared between the external authentication server and the MES-2110.
The key must be the same on the external authentication server and your
MES-2110. The key is not sent over the network.
Server UDP
Port Number
Enter the port number of the RADIUS server. The default port number is
1812.
Server
Accounting
Port Number
Enter the port number of the external accounting server. The default port
number is 1813. You need not change this value unless your network
administrator instructs you to do so with additional information.
Server Time
Out
Type how many minutes a session can be left idle before the session
times out.
Undo Click this to restore your last saved settings.
Apply Click Apply to save your changes to the MES-2110’s run-time memory.
The MES-2110 loses these changes if it is turned off or loses power, so
use the Save Settings link in the navigation panel to save your changes
to the non-volatile memory when you are done configuring.
