BMC Software, Inc., Confidential and Proprietary Information
132 Application Enhancement Solutions Messages Manual
1 A critical function is currently being performed during dummy log recovery
or batch backout.
System Action: The
CANCEL command is ignored and the job step is allowed to
continue.
User Response: This message is for your information only. No action is necessary.
BMC48078A BCF OK TO action, SYSTEM=system, JOB=jobname, STEP=stepname,
PSB=psbname, RUN=(date and time)? Y/N
Explanation: During execution, the Active Job utility encountered an execution
control record in the REGISET to process. Because
ASK=YES is specified, the utility
is requesting confirmation to perform the indicated action. For the execution control
record identified by system, jobname, stepname, psbname, and run date and time, the
following action values are valid:
CHANGE
Update settings in the execution control record in the REGISET to execute
restart processing.
DELETE
Delete the execution control record from the REGISET.
System Action: The action taken depends on your response to the message. A
response of Y causes the Active Job utility to perform the requested action for the
execution control record. A response of N causes the utility to bypass processing for
the execution control record.
User Response: Reply Y or N to this message.
BMC48079W BCF ERROR DURING IMS PROCOPT DETERMINATION, REASON=rc
Explanation: During BCF initialization, the program specification block (PSB)
processing intent could not be determined. The reason code (rc) shown in this
message provides additional information about why the PSB processing intent could
not be determined. The following reason codes (rc) are possible:
1 In a DL/I region, an OPEN error occurred on the IMS DD statement.
2 In a DBB region, an OPEN error occurred on the IMSACBx DD statement.
3 In a DBB region, the IMSACBx DD statement was DUMMY.
4 In a DBB region, the IMSACBx DD statement was not present.
5 In a DBB region, the application control block (ACB) was not found in the
library referenced in the IMSACBx DD statement.
6 In a DBB region, the PSB intent list could not be located. This can happen
when the PSB contains only TPPCBs.
