BMC Software, Inc., Confidential and Proprietary Information
BMC74000–BMC74099 157
BMC74079E THE DATA-IN-VIRTUAL TASK HAS TERMINATED WITH SYSTEM
COMPLETION CODE sss AND USER COMPLETION CODE uuu.
Explanation: The data-in-virtual task has terminated with system completion
code sss and user completion code uuu. The accompanying message BMC74080E
displays the system diagnostic work area.
System Action: APPLICATION RESTART CONTROL (AR/CTL) also issues
message BMC74080E for each four fullwords of the system diagnostic work area.
Processing continues, but an associated task abends.
User Response: The dynamic allocation skeleton probably contains an error.
Review the JES message log, the Dynamic Allocation Parameter List report (found
under ddname ARCDYNPR), and the IDCAMS alternate SYSPRINT (found under
ddname ARCDIVPR). Take corrective action as indicated by the information in these
sources.
The error can also be either a hardware error or an AR/CTL internal processing error.
If it is an AR/CTL internal processing error, save the SYSUDUMP, JES message log,
Dynamic Allocation Parameter List report, and IDCAMS alternate SYSPRINT for
this job. Perform the restart using the IMS system log data set (SLDS), if possible.
Contact BMC Software Product Support.
BMC74080E SDWA+offset AT address - contents
Explanation: This message, which accompanies message BMC74079E, displays
the contents of the system diagnostic work area.
System Action: See message BMC74079E.
User Response: See message BMC74079E.
BMC74081W ssid SUBSYSTEM IS NOT A JES2 OR JES3 SUBSYSTEM
Explanation: APPLICATION RESTART CONTROL (AR/CTL) detected that
subsystem ssid is not a JES2 or JES3 subsystem.
System Action: The contents of the JES data fields stored in the various AR/CTL
control blocks will be blank in the respective AR/CTL data fields. Processing
continues.
User Response: This message is a warning only. No action is necessary.
