BMC Software, Inc., Confidential and Proprietary Information
328 Application Enhancement Solutions Messages Manual
BMC150041I MVS MODIFY JOB STOP COMMAND SIMULATION WILL BE
SCHEDULED AFTER hh HOURS, mm MINUTES, AND ss SECONDS.
Explanation: As requested by a processing option, APPLICATION RESTART
CONTROL (AR/CTL) will terminate the job step after the specified amount of time
has elapsed.
System Action: Processing continues.
User Response: This message is for your information only. No action is necessary.
BMC150042E MVS MODIFY JOB STOP COMMAND SIMULATION TIME INTERVAL
HOUR (hh) IS INVALID.
Explanation: The APPLICATION RESTART CONTROL (AR/CTL) processing
option that requests early termination contains an invalid hour value.
System Action: AR/CTL terminates the task abnormally with abend U1771 and
reason code X’00150042’.
User Response: Change the processing option to use a valid value; valid values are
00 to 23.
BMC150043E MVS MODIFY JOB STOP COMMAND SIMULATION TIME INTERVAL
MINUTE (mm) IS INVALID.
Explanation: The APPLICATION RESTART CONTROL (AR/CTL) processing
option that requests early termination contains an invalid minute value.
System Action: AR/CTL terminates the task abnormally with abend U1771 and
reason code X’00150043’.
User Response: Change the processing option to use a valid value; valid values are
00 to 59.
BMC150044E MVS MODIFY JOB STOP COMMAND SIMULATION TIME INTERVAL
SECOND (ss) IS INVALID.
Explanation: The APPLICATION RESTART CONTROL (AR/CTL) processing
option that requests early termination contains an invalid second value.
System Action: AR/CTL terminates the task abnormally with abend U1771 and
reason code X’00150044’.
User Response: Change the processing option to use a valid value; valid values are
00 to 59.
