Chapter 25 IP Source Guard
GS2200-8/24 User’s Guide
206
25.8 ARP Inspection Log Status
Use this screen to look at log messages that were generated by ARP packets and that have not
been sent to the syslog server yet. To open this screen, click Advanced Application > IP Source
Guard > ARP Inspection > Log Status.
Figure 128 ARP Inspection Log Status
The following table describes the labels in this screen.
Request This field displays the total number of ARP Request packets received from the VLAN
since the Switch last restarted.
Reply This field displays the total number of ARP Reply packets received from the VLAN since
the Switch last restarted.
Forwarded This field displays the total number of ARP packets the Switch forwarded for the VLAN
since the Switch last restarted.
Dropped This field displays the total number of ARP packets the Switch discarded for the VLAN
since the Switch last restarted.
Table 74 ARP Inspection VLAN Status
LABEL DESCRIPTION
Table 75 ARP Inspection Log Status
LABEL DESCRIPTION
Clearing log status
table
Click Apply to remove all the log messages that were generated by ARP packets and
that have not been sent to the syslog server yet.
Total number of logs This field displays the number of log messages that were generated by ARP packets
and that have not been sent to the syslog server yet. If one or more log messages are
dropped due to unavailable buffer, there is an entry called overflow with the current
number of dropped log messages.
Index This field displays a sequential number for each log message.
Port This field displays the source port of the ARP packet.
VID This field displays the source VLAN ID of the ARP packet.
Sender MAC This field displays the source MAC address of the ARP packet.
Sender IP This field displays the source IP address of the ARP packet.
Num Pkts This field displays the number of ARP packets that were consolidated into this log
message. The Switch consolidates identical log messages generated by ARP packets in
the log consolidation interval into one log message. You can configure this interval in
the ARP Inspection Configure screen. See Section 25.9 on page 207.
