Chapter 32 DHCP
GS2200-8/24 User’s Guide
247
32.3.1 Global DHCP Relay Configuration Example
The following figure shows a network example where the Switch is used to relay DHCP requests for
the VLAN1 and VLAN2 domains. There is only one DHCP server that services the DHCP clients in
both domains.
Figure 159 Global DHCP Relay Network Example
Configure the DHCP Relay screen as shown. Make sure you select the Option 82 check box to set
the Switch to send additional information (such as the VLAN ID) together with the DHCP requests to
the DHCP server. This allows the DHCP server to assign the appropriate IP address according to the
VLAN ID.
Figure 160 DHCP Relay Configuration Example
32.4 Configuring DHCP VLAN Settings
Use this screen to configure your DHCP settings based on the VLAN domain of the DHCP clients.
Click IP Application > DHCP in the navigation panel, then click the VLAN link In the DHCP
Status screen that displays.
Note: You must set up a management IP address for each VLAN that you want to
configure DHCP settings for on the Switch.
VLAN1
VLAN2
192.168.1.100
DHCP Server:
