Chapter 35 Access Control
GS2200-8/24 User’s Guide
268
35.5 Service Port Access Control
Use this screen to decide what services you may use to access the Switch.
Service Access Control allows you to decide what services you may use to access the Switch. You
may also change the default service port and configure “trusted computer(s)” for each service in
the Remote Management screen (discussed later). Click Management > Access Control >
Service Access Control to view the screen as shown.
Figure 176 Management > Access Control > Service Access Control
The following table describes the fields in this screen.
35.6 Remote Management
Use this screen to specify a group of one or more “trusted computers” from which an administrator
may use a service to manage the Switch.
Click Management > Access Control > Remote Management to view the screen as shown
next.
Table 109 Management > Access Control > Service Access Control
LABEL DESCRIPTION
Services Services you may use to access the Switch are listed here.
Active Select this option for the corresponding services that you want to allow to access the Switch.
Service Port For Telnet, SSH, FTP, HTTP or HTTPS services, you may change the default service port by
typing the new port number in the Server Port field. If you change the default port number
then you will have to let people (who wish to use the service) know the new port number for
that service.
Timeout Type how many minutes a management session (via the web configurator) can be left idle
before the session times out. After it times out you have to log in with your password again.
Very long idle timeouts may have security risks.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
