Chapter 8 Basic Setting
GS2200-8/24 User’s Guide
78
To view the current amount of power that PDs are receiving from the Switch, click Basic Setting >
PoE.
Figure 47 Basic Setting > PoE Status
The following table describes the labels in this screen.
Table 14 Basic Setting > PoE Status
LABEL DESCRIPTION
PoE Status
PoE Mode This field displays the power management mode used by the Switch, whether it is in
Classification or Consumption mode.
Total Power This field displays the total power the Switch can provide to the connected PoE-enabled
devices on the PoE ports.
Consuming
Power (W)
This field displays the amount of power the Switch is currently supplying to the connected
PoE-enabled devices.
Allocated Power
(W)
This field displays the total amount of power the Switch has reserved for PoE after
negotiating with the connected PoE device(s). It shows NA when the Switch is in
Consumption mode.
Consuming Power (W) can be less than or equal but not more than the Allocated
Power (W).
Remaining
Power (W)
This field displays the amount of power the Switch can still provide for PoE.
Note: The GS2200-24P must have at least 20 W of remaining power in order to supply power
to a PoE device, even if the PoE device needs less than 20 W.
Port This is the port index number.
State This field shows which ports can receive power from the Switch. You can set this in Section
8.8.1 on page 79.
• Disable - The PD connected to this port cannot get power supply.
• Enable - The PD connected to this port can receive power.
